Can skateboard wheels be too tight?

Your skateboard wheels should be tight enough that they spin freely. However, you don’t want the wheels so loose that they wiggle on the truck’s axle. … It’s also possible to over-tighten skateboard wheels, and that will prevent you from getting the most speed out of your board.

How do you know if your skateboard wheels are too tight?

There are no rules for how tight wheels should be. I tighten the nut on the wheel so that the bearings are all-the-way seated into the wheel, and then back it off an eighth or quarter turn. I like them to just barely wiggle back and forth on the axle. This makes them just a little louder and it feels right to me.

Can wheels be too tight?

If the wheel bolts are too tight, the threads might get stripped or damaged. And this is where the torque wrench comes in. … All you have to do is set the value on the tool and then release the lever – as soon as the tightening torque is reached, you will hear and feel a clear click in the wrench.

Why are my skateboard wheels stiff?

Wheels are very tight



One of the most frequent issues that produce a slow skateboard is over-tightened axle nuts. How tight should skateboard wheels be? Over-tightening axle nuts causes pressure against bearings, not allowing wheels to spin.

IT IS INTERESTING:  Quick Answer: What age can a toddler wear a snowmobile helmet?

Are skateboards supposed to be tight?

If you skate street or skate park, then loose is better. If you do flat ground trick, then loose isn’t good because if you fall on the edge of the board, you will fall forward. It’s all a personal preference. I think you should get a tool and try tight and loose.

Should skateboard wheels be loose or tight?

Your skateboard wheels should be tight enough that they spin freely. However, you don’t want the wheels so loose that they wiggle on the truck’s axle. To see if you need to tighten your wheels, put the board on its side, and flick the wheel as fast and as hard as you can with one hand.

How tight should lug nuts be without torque wrench?

You should always check your lug nuts 20 miles down the road after changing a tire. Sometimes, one will loosen up. No car have a torque wrench in their tools set for tire change. That means that isn’t necessary, just tight them until stop moving and that’s all.

What happens if you over tighten axle nut?

It’s possible to damage the wheel, rotor, and hub assembly. The wheel can come off if over-torquing the nuts/bolts is done. The only way to tighten them is with a Torque wrench. …

Should I use WD40 on my skateboard?

It’s important to use a silicone-based lubricant. WD40 or others like it will dry out your bearings and attract dust and dirt. … It doesn’t take much, and the excess will just spin out when you replace your shields, pop your bearings back in your wheels and start shredding. Skate safe and enjoy your new-found speed.”

IT IS INTERESTING:  Can you get into Antelope Canyon without a tour?
Lifestyle Extreme