How do I get rid of loud noises on my skateboard?

Why does my skateboard make a loud noise?

Another thing that can cause noise is vibration between the layers of the deck itself, if the deck is old/cracked, but you can’t do much about that except replace the deck. Higher wheel hardness will transfer more force into the truck/deck, causing more vibrations.

Why do my skateboard bearings make noise?

Bearings only start to make noise when spinning when they have accumulated dirt/ grime. You shouldn’t worry about the silent wheel, you should be more worried about the noisy ones. But don’t be too worried, most bearings are going to make at least a little noise.

Is it bad if your skateboard creaks?

Don’t worry about it, nothing is breaking or anything, infact most probably they are new trucks so it takes some time to break in the bushings. Just keep skating and ignore the squeaky sound. And using WD-40 on bushings is a tad to far.

Why is my new skateboard creaking?

When you hear your board squeaking, it is usually the rubbers in the truck that are too dry. The hanger of your trucks turns in the pivot cup and that makes the noise. It is also possible that the bushings are too dry.

IT IS INTERESTING:  Did Rachel break her nose skydiving?

How loud is a skateboard supposed to be?

The chief noise officer for the Portland Sheriff’s department concluded in a report that skateboarding noise was negligible at 50 feet but that sharp sounds from some tricks (like ollies) could reach 65 to 71 decibels; about the sound of a bat hitting a ball. Other tricks (like grinds) reach between 54 to 65 decibels.

Should bearings be silent?

A good quality, low noise bearing will have excellent surface finish on balls and raceways and the roundness of the balls and bearing rings will be very closely controlled. … Poor fitting practices can cause dents in the bearing raceways which will greatly increase vibration.

Why is my skateboard so slow?

One of the most frequent issues that produce a slow skateboard is over-tightened axle nuts. How tight should skateboard wheels be? Over-tightening axle nuts causes pressure against bearings, not allowing wheels to spin. … With your hand, move wheel side to side to, listen for clicking noise.

Why can’t I turn on my skateboard?

Check the tightness of your trucks.



If your deck barely tilts, it means you have tight trucks, which will make it difficult to turn. If your board tilts easily, it means your trucks are loose; while looser trucks make turning easier, they also make your deck unstable and difficult to control.

Lifestyle Extreme