How do you get sand out of skateboard bearings?

How do you get sand out of bearings?

The shields off (if possible) and dump them in rubbing alcohol. Shake ’em up for a while, take em out, dry them, put the shields back on (if possible) and you’re done! Make sure it’s strong (90% if possible) You’ll need to be fast as alcohol is water based and if let sit, can destroy your bearings.

Is sand bad for bearings?

Keep them clean



Because you skateboard outside through dust, sand, water, mud, etc; your bearings will eventually get dirty and/or wet. When they are dirty, you will notice they don’t spin freely when you flick the wheel and you may also notice they are getting noisy.

Does sand ruin skateboard bearings?

Sand sticks to bearing lube/grease



You’re putting little microscopic rocks in between the pieces that spin. Nothing will wear down the performance of your bearings faster than that.

Is sand bad for your skateboards?

Take care of chips in the deck



The nose and tail are especially vulnerable to it. Make sure to take care of bad chips. Sand down splintered wood, round off sharp edges, and don’t let your tail get so thin it becomes like a blade! These can hurt, and also, they can act as places for the board to fracture.

IT IS INTERESTING:  Who is the highest paid mountain biker in the world?

Can you clean bearings with WD-40?

Chances are you just have to clean and lubricate your bearings. … It’s important to use a silicone-based lubricant. WD40 or others like it will dry out your bearings and attract dust and dirt.

Can I use rubbing alcohol to clean my bearings?

After you’ve let your skateboard bearings soak in the cup of isopropyl alcohol for at least 30 mins, take each bearing out individually and use a paper towel to wipe them clean and dry. … If you’re fortunate to have access to compressed air, apply it now to really clean the hard to reach areas inside the bearings.

What can I use to lubricate bearings?

Good oils are Bones Speed Cream, Tri-flow, and other similar lubricating oils. Motor oil will work too. Bad oils include WD-40 and 3-in-1 (too light). If you use oil, 2 drops are usually enough.

Can you clean bearings without lube?

In removing the oil or grease when cleaning skateboard bearings, you need something which can dissolve the substances. Isopropyl alcohol and acetone are two of the most effective organic solvents that you can use in cleaning the bearings.

How long do skateboard bearings last?

bearings and replacing them at least every two years. Besides replacing your bearings every few years, there are a few more situations when you should consider replacing your current bearings: Your bearings are of low quality. Current ones started slowing down.

Why do my bearings get so dirty?

The first fundamental reason behind cleaning your bearings is friction. Friction is caused by the internal motion of the balls, this friction causes heat and that makes the oil dissipate. So bearings need oil to minimize the damaging effects of this friction. But this oil also makes dirt stick to it.

IT IS INTERESTING:  Best answer: Is a skateboard a conveyance?

Is it OK to sit on your skateboard?

Don’t sit or stand near obstacles people are actively using. Don’t lurk, go there to skate not sit and watch all day. Don’t go out of turn repetitively, once or twice no one will care but if it becomes habitual it’s frowned upon.

Lifestyle Extreme