Why does my skateboard not roll smoothly?

Make sure that your axle nuts aren’t screwed on too tightly. If you didn’t assemble the skateboard yourself then you should check this. If the axle nuts are too tight you could be squeezing the life out of your bearings and causing unwanted friction between the two parts.

Why does my skateboard not roll well?

Bad bearings, worn or “coned-out” wheel(s) or worn down size wheels may be the problem. Wheels get harder with age and exposure to sun and temperature changes. Older wheels perform less well than new ones for these and many other reasons. Basic maintenance can fix most troubles tho, so don’t despair, repair!

How do you fix a skateboard that won’t roll?

Just poke them out with a paper clip. Then soak your bearings in acetone, nail-polish remover or rubbing alcohol. Spin them dry and make sure all the dust and dirt are out. Now you’ve removed all the dirt as well as all the lubricant from your bearings.

Why does my skateboard roll slow?

One of the most frequent issues that produce a slow skateboard is over-tightened axle nuts. How tight should skateboard wheels be? Over-tightening axle nuts causes pressure against bearings, not allowing wheels to spin. We all make this mistake at some point, and a noticeable squeaky rubbing noise results.

IT IS INTERESTING:  Question: Do kayaks scare fish?

Why do I have to push so much on my skateboard?

Bad quality wheels are made way to soft. This causes a certain amount of squishing to the wheels once you stand on the skateboard and put pressure on the wheels.

How do you go fast on a skateboard without falling?

Make sure to center your feet and not hang your heels or toes too much. This will improve your turning and give you stability. You might try placing your skateboard on some heavy carpet so it won’t roll, and experimenting with foot placement. Another thing to adjust would be your trucks and bearings.

Should I use WD40 on my skateboard?

It’s important to use a silicone-based lubricant. WD40 or others like it will dry out your bearings and attract dust and dirt. … It doesn’t take much, and the excess will just spin out when you replace your shields, pop your bearings back in your wheels and start shredding. Skate safe and enjoy your new-found speed.”

How do you move on a skateboard without pushing it?

Place your back foot on the curve of the tail and your front foot on the bolts. Put your weight on your back leg and start making small kickturns, lifting the nose one way, then the other, using your shoulders. Once you feel comfortable with this, pick up speed as you tic-tac the board from left to right.

Should skateboard wheels be tight or loose?

Your skateboard wheels should be tight enough that they spin freely. However, you don’t want the wheels so loose that they wiggle on the truck’s axle. To see if you need to tighten your wheels, put the board on its side, and flick the wheel as fast and as hard as you can with one hand.

IT IS INTERESTING:  Is Sherwin Williams Mountain air blue or green?

How do I make my skateboard slower?

The best way to slow down on a downhill skateboard, is to have harder wheels. It may sound odd, but having harder wheels allows you to slide out the back end of your board, almost like a snowboard.

Lifestyle Extreme